The list of values can be found in the Editor under the Controller Settings tab. There are 2 lists that you can edit. First, specify the length of your list (up to 16) and second, set the values for each element in the list. The sequencer will step through these values.
Starting the Sequencer
To start the CC Sequencer, you’ll need to program a CC Sequence Generator message in your preset. The available options are
Start/Stop: Whether to start or stop the selected sequencer
Engine: Select which engine to apply this setting to
Once/Perpetual: Whether to run the interval once, or perpetually
Cycles Per Minute: At what speed to run the Cycle intervals.
Cycle Multiplier: How many cycles to run in one interval
CC Number: Control Change Number
MIDI Channel: MIDI Channel
When the preset is engaged, the controller will start sending the CC messages with the specified values at the specified interval.
JavaScript errors detected
Please note, these errors can depend on your browser setup.
If this problem persists, please contact our support.